CPU Resource 100% on RB532A (not R5) while using v3.8

Hardware MikroTik hardware general
1

Hi,

We have a problem after upgrade our routerOS in RB532A(not R5) from v3.7 to v.3.8.
CPU resource always peak at 100% and we couldn’t print all routes/bridge port in telnet mode.
We have tried to upgrade firmware from 2.13 to 2.14, but still couldn’t stop cpu load at 100% peak load.

So, we decided to downgrade routerOS to v3.7 and reboot it.
After that, our Rb532A was back normal again.

Any solution for this problem ?
Thanks

2

we found the problem, it will be fixed in the next release. It is happening when you do a print command on the bridge host table.