Hi all,
I’m new using Mikrotik and RouterOS. I’ve setup some CRS in our network, and have some troubles.
I put a simple config at CRS:
- ether2: master port.
- ether3 to ether24: slave ports of ether2.
I think (after read some manuals, posts, etc…) that this is the correct way to get ether2 -to- ether24 working as switch ports, using switch chip and at wire speed (1 Gbps by port).
But I see this in my stats:
All ports have the same Tx traffix (Rx traffic is different by port). Why?
In my others switchs, I get stats from every port independent. Here, I’m getting same Tx stats in all ports (I think that this is the sum of all Tx traffic of all switch ports).
So, how can get REAL traffic stats by port?
Thanks!
