Hi guys
using CRS109-8G-1S-2HnD-IN with routing it loose packets around 1% under moderate load (50kpps, while maximum rating is about 210 kpps from mtk site). Any ideas?
/interface bridge
add mtu=1500 name=loop0
/interface ethernet
set [ find default-name=ether2 ] master-port=ether1
set [ find default-name=ether3 ] master-port=ether1
set [ find default-name=ether5 ] master-port=ether1
set [ find default-name=ether6 ] master-port=ether1
set [ find default-name=ether7 ] master-port=ether1
set [ find default-name=ether8 ] master-port=ether1
set [ find default-name=sfp1 ] master-port=ether1
/mpls traffic-eng tunnel-path
add name=default use-cspf=no
/routing ospf instance
set [ find default=yes ] router-id=172.31.1.103
/ip address
add address=172.18.0.103/24 interface=ether1 network=172.18.0.0
add address=172.31.1.103/32 interface=loop0 network=172.31.1.103
add address=172.16.0.233/29 interface=ether4 network=172.16.0.232
/ip dns
set servers=172.18.0.10
/ip ipsec policy
set 0 dst-address=0.0.0.0/0 src-address=0.0.0.0/0
/mpls ldp
set enabled=yes lsr-id=172.31.1.103 transport-address=172.31.1.103
/mpls ldp advertise-filter
add prefix=172.31.0.0/16
add advertise=no
/mpls ldp interface
add interface=ether4
add interface=ether1
/mpls traffic-eng interface
add interface=ether4
add interface=ether1
/routing ospf interface
add passive=yes
add interface=ether1
add interface=ether4
/routing ospf network
add area=backbone network=172.18.0.0/24
add area=backbone network=172.31.1.103/32
add area=backbone network=172.16.0.232/29
