CRS125-24G-1S-IN Upgrade Issue

[nkukard]

@doneware

@becs

Press Reset button before connecting power to CRS125 and hold the button during boot process until “USR” LED stops blinking.
Check Serial console output while trying to connect to Netinstall PC to see if there are any errors.

please… would it be possible to provide a real, usable recovery procedure which does not require on-site button-pushing?
your higher end devices all have serial consoles.

i can understand, there must be a way to live with boxes w/o serial console. the button-pressing is accepted there.

but with a device located at the customer premises, and with tools you normally provide for troubleshooting (like
wireless spectrum scan, ethernet cable test) which basically reduce the on-field troubleshooting to minimum,
it’s a real shame, that the failsafe procedures did not evolved in any way.

we have OOB devices on the bigger sites, though in case of issues like this we can’t do nothing.
at least a cli instructable tftp client would do the trick.

I have the same issue, I tested upgrading from v6.4+ to 6.5+, in all cases the device is pretty much unusable.
http://forum.mikrotik.com/t/crs125-configuration-help/71632/13