CRS226 basic config

RouterOS Beginner Basics
1

Hi,

I’m having trouble with basic setup of the CRS226.

Long story short, I’m looking for it to behave just as a (managed) switch on the 192.168.1.x network - so I need to change the default configuration IP address from 192.168.88.1 to something else

I’m not sure what the correct setup is - the basic setup allows both bridge and router - I would assume bridge is what I’m looking for, but when I set that, then set the address, I can’t access webfig on the address.

Any pointers?

2

If you find you’ve lost L3 connectivity with something that you’re plugged in to, use Winbox to try and discover the device. That should help you recover.