CRS317 - HW. Offloading only works on a single bridge, is it a bug?

RouterOS General
1

I have found that the HW. offloading works without problems in the first bridge I created.
However, on the second bridge, under the same conditions as the first, there is no way to activate HW.offloading.
Does v6.42.6 on the CRS-317 only allow active Hw. offloading on a single bridge?

2

Currently yes, HW only on one bridge.

3

Are you planning to expand it in future versions?
If so, is there an estimated time frame?

4

make vlans on the bridge to segment your switch, there is no need for multiple bridges

5

You’re right, thank you!

6

I’m not sure how to do it.
I need:
untagged bonding1 <----> untagged bonding2
tagged bonding3 vlan151 <------> tagged port1 vlan151

I had them in 2 bridges because I need them to be totally isolated and I’m not sure how to do it, because there is no drop that I can configure between them.
Could it be enough to use “admit only VLAN tagged” on the tagged ports and “admit only VLAN untagged” on the others?