CSS326-24G-2S+ does not accept dhcp-provided IP!?

SwOS
1

Hello,

I’m trying to integrate my shiny new CSS326-24G-2S+ into my network. And am pluggin it into my dhcp-serving firewall. dansmasq recognizes the switch and offers it my custom IP, but it appears to not accept it and falls back to it’s default (see below journalctl -f log).

What may I be missing?

Sincerely, Joh

ec 22 13:00:18 morannon kernel: e1000e: eth3 NIC Link is Up 1000 Mbps Full Duplex, Flow Control: None
Dec 22 13:00:19 morannon ntpd[1242]: Listen normally on 13 eth3 10.10.3.1:123
Dec 22 13:00:19 morannon ntpd[1242]: Listen normally on 14 eth3 []:123
Dec 22 13:00:22 morannon dnsmasq-dhcp[1241]: DHCPDISCOVER(eth3)
Dec 22 13:00:22 morannon dnsmasq-dhcp[1241]: DHCPOFFER(eth3) 10.10.3.2
Dec 22 13:00:23 morannon dnsmasq-dhcp[1241]: DHCPDISCOVER(eth3)
Dec 22 13:00:23 morannon dnsmasq-dhcp[1241]: DHCPOFFER(eth3) 10.10.3.2
Dec 22 13:00:24 morannon dnsmasq-dhcp[1241]: DHCPDISCOVER(eth3)
Dec 22 13:00:24 morannon dnsmasq-dhcp[1241]: DHCPOFFER(eth3) 10.10.3.2
Dec 22 13:00:27 morannon dnsmasq-dhcp[1241]: DHCPDISCOVER(eth3)
Dec 22 13:00:27 morannon dnsmasq-dhcp[1241]: DHCPOFFER(eth3) 10.10.3.2
Dec 22 13:00:34 morannon dnsmasq-dhcp[1241]: DHCPDISCOVER(eth3)
Dec 22 13:00:34 morannon dnsmasq-dhcp[1241]: DHCPOFFER(eth3) 10.10.3.2
Dec 22 13:01:17 morannon kernel: IPv4: martian source 255.255.255.255 from 192.168.88.1, on dev eth3
…

2

Does the CRS326 have a ip > DHCP Client entry setup? Looks like it’s running a DHCP Server (not client)…

If so, disable DHCP Server, and set a DCHP Client on top of the bridge interface where all ports are.

3

The CSS326 runs SwitchOS and does not have a DHCP server. Although I normally run all of my switches with static IPs, I remember when I first got them and they factory defaulted to DHCP with fallback, the DHCP client worked.
What is the setting of the Address Acquisition on the System tab?
Also, what SwitchOS version (from the Upgrade tab)?