DHCP Auth Problem with Tranzeo?

RouterOS General
1

I have a weird problem with a new MT router set up that is driving me nuts. I have several MT systems running but this one will not issue a IP to any Tranzeo CPE’s. The system is as follows

  1. rap1d board with 2.8.23 level 3 where I am using the ethernet ports only for in and out. The AP is Tranzeo’s TR-4500

The above system will not assign any IP’s to the CPE’s, such as the 80-15’s or the 200-15’s. But will assign to my PDA and laptop with a Proxim card in it.
I have called Tranzeo and the tech told me that there is a problem in the MT code. I started to think on this and I dont belive this is truely it. I have a second system running that is as follows.

  1. rap1d board with 2.8.23 level 5 using a CM9 as the AP

This one works with the 200-15’s with no problems but seems to have Issues with the 80-15 but it gets the IP assigned when I fiddle with the radios IP settings and set it to look for a DHCP address in the 80-15

Things get realy confusing is the third system that I am running.

  1. 150mhz PC with 2.8.21 level 4 using a Tranzeo TR-4500

This last system seems to work flawlessly. The 200-15’s and the 80-15’s work without a problem.

Can any one shed some light on the problem.
I love the MT software and I wont change to something else just to use the CPE’s.
I dont think that MT is a problem but I sure would like some input.
For now I am setting the 80-15’s up as a Static IP but I sure would like to go back to Dia.
Mike

2

The problem with DHCP and the TR-CPE-200-15 was fixed with the latest firmware upgrade available from Tranzeo.

3

Tech support from the CPE manufacture insisted it was with MT but from what I can see the MT is fine. It maybe with the combination of componets that is causing the problem. I’ll check on the firmware just to be sure. Thanks for the input.
Mike