Hello,
In all of the v6 builds that I have tried (including beta RC builds), when I go into the “Neighbors” list, I see the network devices, but not their IP addresses. The only one that always has its IP shown right away is my cisco switch, onto which my AP (Omnitik) is connected. (Note that the Omnitik is configured in bridge mode, so that is why discovery packets pass through it.)
If I wait for a LONG time (say, 30 minutes or more), then the addresses are shown, one by one. But even then, if I close the webif (or the winbox) and re-open it, the same happens.
In v5, all addresses were shown right away, every time I opened the neighbors table.
Has anyone else observed this?