Use as a Routerboard swith a long time in some time now it just stops responding, it does not crash, but no way I can communicate with her, whether the port is connected to it.
One example, did the Netwatch to realize that when it is not ping on a point she makes a beep, to see if it’s catching, yet it does the beep is still on and is not responsible for any ethernet.
The processor is only 3% of use, is little, I did register logs remotely to find out, what did not indicate anything.
All lans are in bridge mode, since I put in all possible ways to bridge, even if this happens, time is a week but still does.
Before I used a Routerboard RB450, I thought it was her problem, now to using a RB493AH doing the same thing. Have I changed font, now I’m using a 12v 5A.
To resolve the moment I’m using the watchdog, directed to an ip, when she misses it restarts, and then back to work normally.
Hi, i had similar problem, and until now i didnt found what was the cause.
The only way i have found was to add my mac to the arp table, and put the bridge arp in “reply-only”.
Until now it´s working well.
btw, version 3.27, rb411a with radio and ether1 on the bridge.
I am exactly in the same situation than mattana and using the same “solution”, the watchdog. In addition to changing the supply, the firmware and the Routerboard I also suppose You have changed the cables (but all the ethernet ports die?).
I tried with other routerboards, but the problem continues, all with low temperature, the problem is that my bridge is very long and with different routes and different costs.