I’m loosing my mind here.
I’m trying to set up a repeater on a router board. CM9 as station connecting to main system and 2511 as AP for clients. 1 client would also be connected to ether1. I put them all under the same bridge but no traffic will pass to the system.
I’m probably missing something simple here. Help is very much appreciated.
Joe
If I understand you, you have
1 radio as backhaul link to main antenna
1 radio as AP for surrounding customers
Ether1 bridged because it has client connected to it
All three interface must be in a bridge together and the backhaul link must transparently bridge traffic properly. ie using EOIP or WDS.
Your problem may be because you are using the Wlan to backhaul link in mode “station” and it don´t work in a bridge… try to do WDS in this interface 
Regards!
Alessio
Yes you both were correct I was missing the simple part of wds station for the backhaul side, I was using station mode.
Its always the easy things that ruin my day
Thanks for the help.
Joe