Dual wan setup troubles

[omersiar]

@matiaszon

/ip settings
set accept-source-route=yes allow-fast-path=no route-cache=no rp-filter=loose tcp-syncookies=yes
/ip firewall nat
add action=masquerade chain=srcnat comment="Srcnat WAN1" dst-address=0.0.0.0/0 out-interface=sfp1 
add action=masquerade chain=srcnat comment="Srcnat WAN2" dst-address=0.0.0.0/0 out-interface=ether8


/ip firewall mangle
add action=mark-routing chain=prerouting comment="pfw WAN1, out WAN1" connection-mark=WAN1_pfw in-interface-list=Lan+ETH5 new-routing-mark=WAN1_traffic passthrough=no
add action=mark-routing chain=prerouting comment="pfw WAN2, out WAN2" connection-mark=WAN2_pfw in-interface-list=Lan+ETH5 new-routing-mark=WAN2_traffic passthrough=no
add action=mark-connection chain=input comment="in WAN1, out WAN1" in-interface=sfp1 new-connection-mark=WAN1_conn passthrough=yes
add action=mark-connection chain=input comment="in WAN2, out WAN2" in-interface=ether8 new-connection-mark=WAN2_conn passthrough=yes
add action=mark-connection chain=forward comment="pfw WAN1, out WAN1" connection-state=new in-interface=sfp1 new-connection-mark=WAN1_pfw passthrough=yes
add action=mark-connection chain=forward comment="pfw WAN2, out WAN2" connection-state=new in-interface=ether8 new-connection-mark=WAN2_pfw passthrough=yes
add action=mark-routing chain=output comment="in WAN1, out WAN1" connection-mark=WAN1_conn new-routing-mark=WAN1_traffic passthrough=no
add action=mark-routing chain=output comment="in WAN2, out WAN2" connection-mark=WAN2_conn new-routing-mark=WAN2_traffic passthrough=no

/ip route
add check-gateway=ping distance=1 gateway=x.x.x.57 routing-mark=WAN1_traffic
add check-gateway=ping distance=1 gateway=x.x.x.245 routing-mark=WAN2_traffic
add check-gateway=ping distance=1 gateway=x.x.x.57
add check-gateway=ping distance=2 gateway=x.x.x.245

Hello @dgnevans

Is this a working example?