Hi!
Some time ago I have bought Mikrotik routerboard RBM33B.
In one of the slots I wanted to have both 2,4 and 5GHz interfaces supported.
I bought Compex WLE600VX card (revision? 7AA) and installed in second PCIe slot. From what I understand, I should have both interfaces available in Mikrotik WinBox GUI.
The cards (as far as I understood searching internet) should work with this routerboard. Checking this post: http://forum.mikrotik.com/t/compex-wle600vx-minipcie-on-rb912uag-2hpnd/79445/1
it should work fine.
However, it looks like is incorrectly detected, and I have only one interface (in section "wireless) where I can setup either 2,4 or 5 GHz interface. There is no second interface available.
In addition, this board is in WinBox detected as Atheros AR9888, where the manufacturer says it is a Atheros QCA 9882 chip installed.
When I check the system resources, under PCI tab the board is identified as: Atheros Communication, Unknown device (rev: 0), vendor 0x168c, device 0x003c.
So maybe this is some problem with detection of the board?
Do you have maybe any suggestions about the card?
Thank you! Best regards