Eoip and multicast tweaking

Hello,


Can someone please assist on howto tweak and optimize Multicast stream. I’m running RB2011uias-rm on both sides using OS ver. 6.41rc47.
I have 2 problems ATM:

  1. Sound is flickering and picture hangs from time to time for a split second. I don’t have problem with pixelation and picture tearing
  2. On receiver side when I connect interface it collect’s ip using dhcp from sender (multicast) side.


    I connect eoip tunnel between A and B side using public internet. Let’s say that A is sender (multicast) and B receiver side.

A side:

Mikrotik Eth1: public internet
Local network is 192.168.5.1/24 and playout is located on 192.168.5.62. Multicast is set to 235.45.10.1 port 1234

On this side I have Cisco router that is responsible for dhcp server and wan block. Mikrotik I have only public internet, eoip tunnel and bridge setup.


B side:

Mikrotik Eth1: public internet
As I said when I connect to interface on receiver side it picks up ip from range 192.168.5.x. I test using VLC and stream play normally apart problems I already mention.
On this side I also have only public internet, eoip tunnel and bridge setup.


On both sides I enabled IGMP snooping.

Hi,
Did anybody managed to solve this same problem on every multicast over eoip transfer?