Expert Required for Implementatingf Network Diagram

RouterOS General
1

Summary:
We are looking for a Mikrotik / Cisco expert being able to configure and supply running configuration for network design as specified in Attachment 1 for Cisco and Mikrotik Switch/Routers

Requirements:
You have expertise knowledge of OSI Layer2/3 communication protocols and IOS/ROS and
Mikrotik CCR /CRS
Cisco 3750
Cisco SG200

Supply:
We supply running RDP connection to preconfigured Win7 PC, SSH, WinBox, Telnet and TCP 443 access to individual devices as requested. We supply all hardware devices as defined in Attachment 1 with cabling as layout as outlined in Attachment 1


https://www.freelancer.com/projects/Engineering-Cisco/Network-Design-Implementation.html
network design.pdf (36.8 KB)

2

Just as a note based upon my experiences channel bonding on the CRS is currently done in the CPU, which is limited by a 1Gb/s uplink from the switch chip and the speed of the CPU chip. I have found that bonding on the CRS actually achieves a slower speed than not bonding, and using the hardware switch chip. I have found that speeds of about 250Mb/s were the resultant real world speeds when performing CPU based switching on the CRS. However, the CRS should in a later software release should gain hardware based LACP bonding, according to the MikroTik reps on the forum.

3

Great tip! many thanks for that!