Hi all, 
I bought a RouterBOARD RB750 but I have some problem to complete my first configuration.
I would like to put the VLAN 10 and VLAN 20 on eth2 and eth3 with two DHCP pool (10.10.10.x and 10.10.20.x) and also the VLAN1 common to all ports (to permit traffic between Ubiquiti controller and the UAP AP).
All traffic NATTED from eth1 (192.168.1.199) with default gateway 192.168.1.1.
I enclose the export of the configuration.
Regards
Alex
Config.txt (12.4 KB)
No one that can help me!!! 
Regards
Alex
You can bridge ports 2 and 3 then put the VLAN interfaces on the bridge. Then put your DHCP servers on their respected vlans.
Tnx for your reply!!
The bridge is a “trick” to duplicate the port and simplify my config or is to solve my config problem?
The other config parameters (NAT, default gateway, ecc.) are formerly correct?
Regards
Alex
I tried the bridge option but also something goes wrong and also I think that is only a config semplification.
What is wrong in my config? 
Regards
Alex