Hi there,
I acquired an CRS305-1G-4S+IN for use as an managed switch in my 10GBit network where it shall replace my current Netgear GS110EMX - everything is already configured with VLANs.
I’d describe myself as an advanced amateur in networking as I am quite familiar with linux administration in SOHO environments, I have been administrating OpenWrt installations for ~8 years by now.
I connected my Laptop through ether1 and setup the necessary VLANs upon the SFP-interfaces, plugged in the jacks (DAC/2*RJ+10/RJ+01) and everything is just working. Nice! 
What doesn’t work is the access of webfig from any other interface (goal: from all interfaces) than ether1. Until now I
- set address acquisition to static IP 192.168.55.3
- put ether1 to LAN
- put all interfaces to bridge
What do I need to configure in order to make the CRS accessible from all interfaces?
Best regards,
10010100