I have not been able to get a Groove 2Hn to run EOIP tunnel through the RF side. Seems to work ok on the LAN side, but will not pass data on the WLAN side. Anyone else seen this?
Here’s some code:
From the AP:
IP address 172.30.1.1/24 wlan1
EOIP tunnel 1. IP = 172.30.1.2 Tunnel = 1
Bridge1. Ports = ether1 and EOIP tunnel 1
On the Groove:
IP address 172.30.1.2/24 wlan1
EOIP tunnel 1. IP = 172.30.1.1 Tunnel = 1
Bridge1. Ports = ether1 and EOIP tunnel 1
Does not pass data. Wlan1 on the groove connects just fine to the ap, but no data is transferred to ether 1 on the Groove.