Groove 52HPn Frequencies

RouterOS Wireless Networking
1

HI,

I have a problem with the Groove 52HPn frequencies, I’m using 2.4GHz with a 5MHz Bandwidth B/G/N.

I have set frequency mode to superchannel and country to South Africa.

My ROS is 6.6 with Firmware 3.10

Problem;
I have some interference issues at high site and need now and then to change the frequency to a in between channel eg. 2439 or 2444 where this is not a listed channel, this is only to have a moment for the interference to go away and keep my clients connected to the internet, after an hour or two I reset to a normal channel again.
With the Groove 52HPn I can’t use these frequencies except for the normal channels.
It doesn’t even pickup the sectors on the scan function.

Is there a way to get pass this as I don’t know what ells to try.

Thank you

2

those are not the standard frequencies and those are not supported by AR9300 chipset based wireless cards. Try to use different wireless frequencies that are in the wireless frequency dropdown field.

3

That is what I’m doing now, the thing is that I have been using some of these frequencies at times I have interference on my high site, The old Groove 2Hn did work with the non standard frequencies but this new groove 52Hpn does not support this now, little bit disappointing but I have to live with it.

Thanks