Groove LED lights gone after upgrade!

Hardware MikroTik hardware general
1

This must be some sort of bug, but not serious, more irritating…
After upgrading Groove from factory delivered status into v5.7 all LED lights don’t function any longer.
I found all settings were erased:

[admin@MikroTik] /system leds> pr
Flags: X - disabled 
 #   TYPE                     INTERFACE                    LEDS                  
 0   wireless-signal-strength (unknown)                                          
                                                                                 
                                                                                 
                                                                                 
                                                                                 
 1   interface-activity       ether1

or

[admin@MikroTik] /system leds> export
# jan/02/1970 00:07:12 by RouterOS 5.7
# software id = JR1Z-VDIZ
#
/system leds
add disabled=no leds=,,,, type=wireless-signal-strength
add disabled=no interface=ether1 leds="" type=interface-activity

Un desired behaviour for an upgrade!

MT should correct this in next upgrade imho…

2

And how to bring them back for the interest:

Insert following code cut and paste in terminal at the prompt:

/system leds
remove [find]
add disabled=no interface=ether1 leds=user-led type=interface-activity
add disabled=no interface=wlan1 leds=led1,led2,led3,led4,led5 type=\
    wireless-signal-strength
3

Hi,

Also happened to one SXT in the first batches produced after upgrade to 5.7.

Rgds,
Mark

4

we fixed the problem in v5.8, so if you have an older model with LED config and you don’t want to lose it, don’t upgrade to v5.7 but wait for v5.8

5

Hi Normis,

I had already upgraded the unit. What I did was to reset the LED settings for the wireless via winbox which seemed to fix the issue, at least visually.

Rgds,
Mark.