Grounding Issue / Prevent Equipment Damaged from Lightning

RouterOS Wireless Networking
1

Dear All,

What’s step / technique do you think most effective
in order to prevent equipment damage (wireless & routerboard)
from : ESD, EMI, lightning strikes (indirect) ?

Please share your usuall step, trick, secret, and
your experience regarding it ?

Thank you very much…


//Budi

2

Antena---->coax------>Lighting arrestor()---->Routerboard()----->Outdoor PoE protector()------>Indoor PoE protector()------>Inyector------>120 VAC protector and Ethernet protector(*).

(*)All this component, connect to common ground. This common ground is the same of the building.

Both routerboard (230 and 500) have ground connection to chassis.
[/img][/url]

3

Dear Msolis,

  1. Do you put routerboard in metal enclosures, and ground that
    metal enclosures too ?

  2. What if the routerboard located in tower, do you ground
    them to tower mast (pipe / galvanized stell) or do you ground
    it to ground cable ?

  3. What’s type out outdoor POE surge protector that you
    recommend to use ?

  4. What method do use for connecting the POE surge protector
    to common ground ?


    Thank you very much..

//Budi

4

what you meant by outdoor & indoor poe connector..

5

some info here: http://wiki.mikrotik.com/wiki/Grounding

6

If this is a water tank or rooftop, we typically bond #2 stranded ground cable from a copper bus bar near antennas. You will then want to bond everything to it: enclosures, coax (via coax ground kits), and antenna masts. If this is a commercial tower, there is typically a ground system or bus bar that can be connected. If not, then we sometimes run a #2 down the length of the tower (which can be expensive). You will then tie the #2 wire to a set of 3-4 ground rods. Make sure everything in the building is also bonded back to this ground point (usually near base of tower or water tank). If it is a large tower, we usually drive about 6-8 ground rods and tie them into a halo around tower base. Make sure everything is bonded together, or it can mess up the whole system. If you do it correctly, you can take direct lightning strikes to the tower structure and not lose your equipment.