Good afternoon Gentlemen.
I am currently busy testing 2 brand new out the box sxt’s and i am having a hard time.
I need to know what information all is required to get some assistance on this.
I have read a lot about DP links, and 802.11N I am able to get
108mb/108mb when i run:
SXT <=> 31DB Grid
The moment i change to SXT <=> SXT the link barely gets over 36mb/s
i have tried the above controll and below controll ht, just to be sure, the freq i selected looks clear from both sides, and seems to have enough space for the 40Mhz band needed,
The issue that im having is that my
Chan0 = -92DB
Chan1 = -71DB
All Chains Enabled both sides
The 71DB is enough to allow me to get into N rates, but i am not even getting 54mb, and my ccq is something that horrors are made of stagnating at 5%/7% (sxt <=> sxt)
Sxt to Single pole 31DB grid at the same Freq i get up 2 108mb/s with a above 80 CCQ
31DB <=> 31DB i used to get 135mb/s (ht guard long) at 95CCQ (both sides R52hn Cards at Txpower - 12db ) (-61db-d63db)
Line Of sight Picture is here.
http://www.wug.za.net/newlos2.php?fl=34&tl=11643
Now from My really minor math skill i have worked this out in my head, but it might be completely incorrect.
Old
31DB grid + r52HN @ +11DB = 42DB Signal
New
16Db FP + SXT @ 22db (DP) = 38DB signal
So i should see a Difference of 4DB if i had to swap the equipment out and run it as “new” aka SXT @ 22db, The problem is that im experiencing the one chain at -93 and i believe the Noise floor is around 100~105, and thats no good (14 odd SNR).
The actual Question is => what do i need to post here so that we can work through this, Its my First DP install, and i might have missed something, my thinking is if i have missed something then most people will.
Have all mcs’s def, all freq def, 802.11N HTC Guard Long (for safety longer time to read packet if there was interference that i really don’t think there is), all chains enabled, 1 ampdu seleceted (0).
Anyone with any ideas?