I got a problem and i don’t seem to figure out a way around it.
I have two radios (each with RB with 4.9 Wireless card) connected point to point. I’ve set the link as a bridge via EOIP and i have cisco routers at both ends. A bandwidth test between the radio link gives a throughput of about 12Mbps. however, the bandwith between the ether interfaces( where my routers are connected) sometimes get clip at just 2Mbps. I have to restart both radios several times before am able to pass traffic above 8M.
Any ideas what might be wrong…
i did run a tcp bandwidth test from winbox from one radio too the other radio interface. the signal strenght is between -45 to - 55dB…
Am actually running on the 4920MHz licensed feqency band..
the link was to get connectivity to my ISP’s premises. so i just needed a bridge to the premise and did use an eoip tunnel fro that.