Can you please help me to configure my mikrotik equipment in station mode and it would be possible to connect four computers on the Ethernet ports 2,3,4 and 5 they receive internet.
Router: RB751G-2HnD
RouterOS: V5.26
I plug on the Ethernet N°2 to configure the RouterOS
I did:
“Wireless”:
Mode: “station”
Country, antenna gain, etc. … → it is OK.
\
“Quick Set”:
Mode: Router
Acquisition Address: → DHCP
LAN IP ADRESS: 192.168.88.1/24
NAT: Ok
Apply Configuration
I click “disconnect”, I can see all wireless networks, I can connect to my AP:
The signal is excellent
I enter the wpa key
I click on “Connect”
DHCP gives me a WLAN IP Address and Gateway → this is perfect
But not having internet on 2,3,4 and 5 ethernet ports?
Please, could someone help me to correct me, being explicit because I am a new user mikrotik, thank you in advance.
I’ve looked at the manual and wifi but I did not succeed since 3 days.
If I ask for help, it means that I am a novice in network so why do you give me two links that are incomprehensible. I am not a technician network! Your answer (your links) are confused ^ ^
@ Rudios
1°) There is a wireless AP out (hotspot) ok?
2°) I connected a cable to the RJ45 Ethernet N°2 of my RB751G-2HnD router to configure my wireless router (with the quick set up) mode station that connects to the outside hotspot ok?
3°) I managed to connect to the wifi hotspot, the signal is very good, ok?
4°) I would like to connect computers to each ethernet port router RB751G-2HnD, ok ?
4 computers on port ethernet routeur wireless (mode station) ----> AP hotspot wireless outdoor
5°) What is the configuration required for ethernet ports? Can you just explain to me and do not give me links wiki mikrotik is incomprehensible, thank you
You can’t easily bridge to the wireless network if station mode is utilised. Station mode is generally used for back haul wireless links. If want a wifi access point for iPads, phones and laptops, etc you should change the mode to wireless AP and create a bridge with ether, wlan etc
