Hi!
I have huawei hg8245h router. And all works fine. But i want to raplace it with microtik. I try to setup internet on microtik and i didnt can. Please help. In atach there is a picture with huawei hg8245h internet options. How i do the same in routerOS. I try to create VLAN interface with ID 40, and ID 2347. I try to install multicast module. I setup internet on routerOS many many time, but never with VLAN. And i dont understand what mean multicast vlan. Can anybody help me???
MikroTik is very a very different but rewarding product. You’ll need to devote about 100 hours to study their way of doing things. Start here. We’ll chat again in about in two weeks.
I know that being rich is better than being poor. And it’s better to take courses, and even better to graduate. But we have what we have. 1804RE8551 MTCRE, 1804NA7984 MTCNA. These are the courses that I attended. What is the course about my problem? Or maybe you think that a dint try to find decision in internet? And so, of course, I, too, for all good versus all bad.
You can add vlan id:40 on ether1. Stops here because in screenshot you not have any Public/Private IP or information this WAN link is dhcp-client or stg. other stuff and of course you can try setup the dhcp-client at vlan id:40.
Maybe before that you must setup a MAC address at ether1 and vlan id:40 too. This depend of what ISP checks to verify devices.
Other way is setup one MikroTik as two ethernet port bridge - no ARP, no Addresation at this bridge.
Next connect ethernet from your ISP and ISP devices that MikroTik can look at bridge and see traffic in VLANs like vlan id:40.
I hope give you some idea to do. Good Luck and give us feedback 
On screenshort there is wan ip. My last idea to add two vlan interfaces one for ip and one for igmp proxy. If i have two different vlans can i ping host int another vlan?
Ahh, yes.
Then you create vlan40 at etherX and assign IP address at vlan40.
Next is to add default route.
Remember, maybe you must set a proper MAC address.
You can add other vlan too. This is common with voip/iptv/internet providers.
Yes, you can regulate icmp at firewall and allow/block pings.
this is my account (held88)
I already did it. No result. I cant ping gateway. Additionally, i installed multicast module, created vlan 2347, and used it for igmp proxy. No result. Thats why i come here. Have anybody some ideas?
One, debug it by:
Other way is setup MikroTik as two ethernet port bridge - no ARP, no Addresation at this bridge.
Next connect ethernet from your ISP and ISP devices that MikroTik can look at bridge and see traffic in VLANs like vlan id:40.
Of course it ISP provide Ethernet to device who have screenshot.