This is the best document for reading prior to setting up, sorry I didnt link it before.
http://forum.mikrotik.com/t/using-routeros-to-vlan-your-network/126489/1
Two comments.
- the vlans interface is the bridge not etherports
- set this to none as its known to cause issues
/interface detect-internet
set detect-interface-list=LAN internet-interface-list=LAN lan-interface-list=
MGMT
okay one more
3. Your bridge ports do not jive with the diagram, eth2 and eth3 look like they are going to dumb devices and yet you have trunk ports indicated in the config??
Eth4 carries all vlans to the next node, the switch.
sorry saw something else
Ether5 is your emerg access, therefore in IP address the interface is NOT the bridge but ethernet 5!