Hi,
Since last update I have problems that my cpu after 24h goes from 10% to 60% and higher. I used snmp and after I saw someone have same problems found here on forum I disabled it. That didn’t help me, I turned off snmp yesterday and again cpu usage is like 70%. Most of CPU takes management profile everything else is in most cases maximum 10%. My graphs shows me that cpu every hour goes for few % up.
RB951-2HnD
Did someone else have same problems?
Thank you
Regards
no one have any problems like me?
Just found out my kid control rule for just one mobile device cause this.. Disabled and CPU went from 50% to 5%…
It sounds like something that MikroTik support could be interested in. You can create supout.rif when it’s happening and send it to them.
Do I have to make supout.rif file while my MT CPU goes high or I can do it anytime?
When it’s high should be better choice. They may have some logs saved, but as far as I know, exact details are not public knowledge.
I had the same problem. I resolved that by downgrade to 6.42.7 then export. Next reset to no-default and line by line import configuration.
Wysłane z mojego SM-J510FN przy użyciu Tapatalka
You don’t have kid control rules?
I sent email to support with supout.rif file immediately after I activate kid control my cpu goes from 3 to 40%. I will inform you if support contacts me back.
Nope. I doesn’t have any Kid Contorl rules.
Unfortunately I couldnt generate supout.rif because then my router hangs out.
Wysłane z mojego SM-J510FN przy użyciu Tapatalka
Hello, it seems that is problem with firmware 6.43.2. I have internet connection from my ISP 300Mbps down/20Mbps up. When i tested my internet speed link via speedtest.net i was not unable over 150Mbps and CPU usage raised over 60%. Today i replaced my router with new model and problem solved. I think that this problem is “model specific”.
Cpu load > 60% on RB951G-2HnD and unable get over 160Mbps.
Cpu load < 30% on RouterBOARD 962UiGS-5HacT2HnT and max speed over 300Mbps.
Simple SOHO config, 1 Wifi, 1 subnet, NAT, < 10 firewall rules. port forwarding. Nothing special.
I can confirm that also on my 951 also speedtest 120/10 with packet mark and queue activate cpu load almost 100%
2 parent tree for download and upload and 10 child / 5 for each, I used this for ping and game priority
14 packet / connection marks
Found documentation about my device and think that should not cause 90% cpu load.
At the end I had to turn off everything because I though I didn’t configure it ok, seems I m not alone…
Try add this rule if missing 
chain=forward action=fasttrack-connection connection-state=established,related log=no log-prefix=“”