I need someone to help me out in my hotspot programming(configuration).So far my router is working very well but immediately I connect the wireless to the hotspot nic in my router,the router will stop working.Am using Level 4 license and v2.9 router Os.
Here’s the detail of my configuration.Anyone can correct me in anywhere i missed it:
I have three NIC’s installed in my router machine.
I named them as follows:
Ethern1(Lan),I called Local
Ethern2(Wan),I called Public
Ethern3(Wireless),I called Wavelan(hotspot).
I assigned them the follwing IP adress:
Local:192.168.1.2/24
Public:80.78.18.98/29
Wavelan:192.168.0.2/24(hotspot)
Default gateway:80.78.18.97(Public)
I also did firewall and Bandwidth management.
The last thing I did was the setting up of the hotsopt to the wireless interface,using the setup command.
when i tested it with two NICs Wan and Lan it was ok but when I connect the AP(radio) to the Wavelan Nic it gives me request time out.Why???
Help out.
I connected from modem with cross cable to the Public Nic
then stright cable from the lan Nic to the switch
the cross cable again fron the AP(Wireless) to the Hotspot(Wavelan) Nic.
Someone should criticize me.
Achai