How are wireless cards supposed to show up?

RouterOS Beginner Basics
1

I have a RouterBOARD 411A and was given a few R52’s and I can’t tell why they’re not showing up when I do “/interface print”

either all the cards are dead or I’m not using the right command to go looking for them. I figured I’d insert a card while the board is off and then power on and it’d show up.


[admin@MikroTik] > system resource irq print
IRQ OWNER
1 [virq-cascade]
2 [pci-cascade]
4 ether1
6 APIC
7 timer
19 serial port
23 [beeper]
48 [PCI ath0]
[admin@MikroTik] >

[admin@MikroTik] > system resource pci print

DEVICE VENDOR NAME IRQ

0 00:12.0 Atheros Communications, Inc. AR5212 802.11abg NIC (rev: 1) 48
[admin@MikroTik] >

[admin@MikroTik] > driver print
Flags: I - invalid, D - dynamic

DRIVER

0 D Atheros PCI
[admin@MikroTik] >

2

I joggled the unit by reflashing 3.30 onto it and now things work fine.