I am using a router board RB433AUH via wireless to trunk two cisco 2960 switches together. The Trunk port is set to be native 146. I have successfully trunk-ed across the wireless bridge, but can not figure out how to create access to either of my MT wireless devices over the trunk. (need to be able to manage both radios while passing the trunk)
This is a flat network, no routing is going on.
I have tried adding a bridge with both the WLAN and ether1 with a VLAN 146 added to the bridge for management with no luck.
What am I doing wrong? 
Connections:
Laptop connected to Cisco switch port on VLAN 146
RB433UAH connected to Cisco trunk port that has native vlan 146 configured.
Laptop can not ping RB433UAH through the cisco switch (interface of RB not being untagged?)
Thank you in advance.
Matt