How to Add routing/rb unit to my existing setup.

RouterOS General
1

I will use public ip as an example setup.

My current system starts with

rb532 with two 400mw cards
192.168.1.254/254 eth0 mikrotik unit.
192.168.2.1/254 wireless1 (802.11a) - Link to relay
192.168.3.1/254 wireless2 (802.11b) - To Clients

I use the 802.11a link to a tower

rb532 with three 400mw cards (daughterboard)
192.168.2.2/254 wireless1 (802.11a) - Link back to office (Bridged)
192.168.2.3/254 wireless2 (802.11a) - Link to next relay (Bridged)
192.168.4.1/254 wireless (802.11b) - To Clients

I am told my reboot problem is due to the three 400mw cards on the second unit. Using differnt cards is not an option, I have settled on using all the same Senao NMP-8602 cards a large quanity in stock. I have the same cards in all clients.

I need to split the relay above that has three 400mw cards into two rb532’s. How should I do this?

2

umm.. did I give to much info…

ethernet a-Radio a—> radio b- ethernet b —>ethernet c-- Radio c.

The feed ip is 192.168.1.254
Radio A is 192.168.2.1
Radio B is 192.168.2.2

Then what?
Ethernet b = 192.168.2.3
Ethernet c = 192.168.2.4
Radio c = 192.168.3.1

Does that work? and what do I just setup bridging on the first radio with wlan1 and ether1 ?

Radio