how to configure this link?

RouterOS Beginner Basics
1

Hello,

I want to do this wireless link, it is quite confusing, so I make a photo.

http://img59.imageshack.us/i/mikrotik.jpg

Could someone help me?

Thank you!

2

If ur cable modem does not have multiple lan ports, Put a switch in between the cable modem and linksys(1) so u can have a separate cable from the switch to the 433ah(1). configure the 2 433ah as transparent bridge. then u can use the remaining 2 public ip’s on linksys (2) & (3) assuming all the 3 public IP’s from the same subnet.

3

If there is all system in bridge mode then these IP addresses can be where ever they are and being on the same subnet is not important.

4

i assume he has been provided with 3 public IP’s on the same cable modem. neways if he has 3 he can use them any whr he likes across the bridge :slight_smile:

5

Hello everybody,

Yes, the cablemodem has a switch with 4 ports, and my ISP only give me 3 public IP’s. I will try all your recomendations, I will tell you what happens.


Many thanks!!

6

Hi again,

I am not able to do the link. I put the RB433 (A) in bridge mode, and I could get the public IP on wlan1 of RB433 (B). But then I try to do bridging in RB433(B) with eth1 and eth2 but it doesn’t work… I try several ways, with WDS, with EoIP… there are a lot of types of tunnels, but i can’t see any manual to see how does it work, and which is best in each case.

Can someone help me?

7

u dont need to bridge eth1 & eth2 on 433(b). u need to bridge wlan1 and eth1. thr after put a switch out of eth1 and the connect ur linksys(2) & (3) to ports of that switch. u dont need eth2 of 433(b).

8

it works!!! nice!!!

and… is there any possibility to put the linksys in client mode, so the RB433(B) take 2 Public IP’s? (imagine, eth1 for 1ºIP and eth2 for 2ºIP)

In that case, RB433 (B) works as router (with DHCP enabled), so I can apply queues to clients and I have more control…


Thanks!