Hi for all. I have a lobometrics 912, that comes with a RB411U and a Wilstron CM9 for Wireless Module (a/b/g). I was buy an R52N-m for replace a existing CM9, i was install it, but RouterBoard doesn’t show any wireless interface.
I have to install something driver?
How can install the wireless module??
Thanks.
You can contact with me via email.
You need to netinstall with 4.x version.
Buenas noches Martín. Ya he conseguido instalar la tarjeta R52N-m actualizando el ROS desde la version 3.30 a la 4.17, siguiendo los pasos que me han indicado en otro post:
http://wiki.mikrotik.com/wiki/Manual:Upgrading_RouterOS#License_issues
Muchas gracias.
Te conozco del foro de 34Telecom, que yo también estoy registrado por allí, pero no quieren dar soporte a este tipo de cosas.
Saludos.
; )
If you have any problem or you need something else… You know my email! I can help you with the lobos.
Good night. I have a little problem. I bought one which came with Lobo912
a RB411U, firmware 3.30 and a wifi module CM9 100mW. Well, with this
configuration, network scanning was available to me, and was about 70.
Yesterday I decided to upgrade the board to firm 4.17, so I recognize the
R52NM card also acquired in 34Telecom. Everything went right and
recognized, but now, when scanning only detects 20 networks. I
say that the settings are exactly the same as above (Ap-
Bridge, 2.4 GHz b / g, 2442, …).
Is it possible that the card is not working properly?. I ask
this, because the card has 2 MMCX connectors, and does not indicate what each
one. I then connected the pigtail (MMCX - N / H) to one of the connectors and me
gives this result.
Should I change to another MMCX connector wireless card, or is
there is something configured correctly?
Greetings.
Yo need to use 2 antennas or configure it to use one chain only.