how to separate send & receive traffic ?

RouterOS Forwarding Protocols
1

hi friends
i would like to separate send traffic and route them to a defferent interface . for example receive from eth1 and send to eth2 . how can i do it ?

2

Needs more details.

3

this might help

http://forum.mikrotik.com/t/dual-setup-with-ospf-full-duplex-link/27510/1

4

thanks for attention .
I use a VDSL link for internet in my place and i have a very simple problem . until i just download i have no problem and i can download with 34Mbps but when i start to upload , it maximum reaches to 1.2Mbps and the link starts request time out ! now i’m looking for a solution for this . i think if i route my upload traffic to another interface and use another VDSL link just for upload , maybe it solve .but i dont know how can i do this ?
2 VDSL links , 2 interfaces , 1 for download and other one for upload . At the both sides i have RB1000 . so help me please .

5

Are you sure you control both sides of the vdsl? doesn’t your provider have control of their side of the vdsl?

Well if you do, then you can use this : http://wiki.mikrotik.com/wiki/OSPF_to_simulate_full_duplex_links_with_redundancy

6

finally it works .
thank you very much .
your post was realy useful .