Dear All,
I’m testing 4 RB433 with a unusual configuration: I’m trjing to have dynamic mesh configuration.
What I would like to do is to make all 4 unit communicate each other, but dinamically.
In particular I’ve made the following setting for each board:
Mode: AP Bridge
WDS Mode: Dynamic MESH
WDS def bridge: Bridge1 (with RSTP protocol).
ESSID & Freq equal.
No routing is required; all units is transparent for the traffic.
All units can communicate each other, but one is like an AP for all others (and this can be good for me).
The problem is that if I switch off this unit, I would like all other units to automatically link each other (and this doesn’t happen!).
Is there anyone that can help me with some suggestions?
Any feedback is very appreciated.
thanks and regards
Giovanni