how to setup...

Hardware MikroTik hardware general
1

hey all.

i´m new to mikrotik and router os… (was running alix2c3 with debian before)

i got the following situation:

120Mbit Cable gateway
|
port1—RB450G--------------------------
|- port 2 (dhcpd running) |— port 3 → one laptop (should receive ip from dhcp too)
|
switch
|
some LAN devices

my problem is, that the laptop on port 3 doesnt receive an adress from dhcp. if i give him manually an ip adress, no i-net connection.
the laptop should not be at the switch (which would be the easiest way)

i need to configure the RB450G to give an ip adress on port 3 and let port 3 access the internet.
how can i say that ?
port 3 needs to be configured like port 2 and act like port 2. i would like to put a switch on port 2 AND port 3 and do them act the same way.

src nat wirh masquerade enabled for the gateway port 1

switch to all ports


what do i do wrong ?
if you need morre information let me know



sorry for my bad english.


odm

2

You can create Bridge and add ether2 and ether3 in Ports…
Than set DHCP interface to broadcast on bridge1 interface…

3

hi,

i set up as you said.

created bridge, added the local ports 2 and 3.
changed dhcp setting to bridge instead of port 2.

now i got dhcp red lined as invalid. if i change back dhcpd to local port 2 dhcpd runs, but not on bridge

4

You need to add ip address on bridge1.

Something like 192.168.0.1/24
And set dhcp pool something like 192.168.0.100-192.168.0.200 and assign it to Your dhcp server.

5

Hello ,


Regarding This issue , Friend use this instruction below :

add – bridge include [ether2+ether3].
add-> ip->address->192.168.1.1/24 to interface ->bridge.
add->pool → name: pool1
address → 192.168.1.2-192.168.2.254
add->dhcp server → name new →
interface ->bridge →
lease time:3d 00:00:00 →
Address pool-> pool1
add->hotspot
name->server
interface->bridge
address pool->pool1
login->login-hs

are you need further information please contact with me on Y! id…