How to Wireguard Back to a Specific VLAN Subnet?

RouterOS General
1

I have VLANs setup, one is an admin VLAN. How do i set up wireguard so that I can connect to thr admin vlan?

2

By allowing WireGuard source IPs to the admin subnet and denying access to anything else for those source IPs in the firewall

3

When you say “source IPs”, is that in the Allowed Address in the Peer setup, or in the Client Address?

4

More likely firewall or service filtering based on the source subnet.

1 Like
5

In my case, the VPN client device uses an IP adress from the same range as the wgX interface and that subnet is also named as the allowed adresses subnet if I remember correctly

The source IP filtering is done by firewall rules