Huawei E220 on RouterOS v4.9

RouterOS Beginner Basics
1

Hello

Just acquired a routerboard 433uah and upgraded to v4.9 stable. I have been following the wiki for usb 3g modems and have have become stuck at port print command. It only shows the serial port and not a port for the usb modem. Yet under system resource usb print, the 3G modem is listed. Someone did as the question under v4.6 but that was not answered.

I hope someone can help here?

Thanks
M

2

Try to unplug and plug the modem,
test RouterBOARD with another modem (the same model).
As E220 listed as supported on wiki page,
http://wiki.mikrotik.com/wiki/Supported_Hardware

3

If still no port shown, Pos firmware issue (revision).. ??

Try a supout to support and referance this thread.