how communication is done between wireless interface and ethernet(LAN) interface
i can not ping the pc which is connected in wireless interface from the pc connected in lan interface.
how to solve that?
i have routerboard 951g-2hnd.
wireless configuration:
mode = ap-bridge
arp= enabled
Have you created a bridge and then added ether port and wireless port to the bridge?
yes i have created a bridge.
but should i have to give the ip adress and dhcp set up to bridge?
and what ip pool i can assign to wireless interface , LAN interface and bridge?
can i give the same ip pool to all of them?
Assign IP addresses etc to the bridge only. Ports in the bridge lose their identity when they are part of a bridge.
Why don’t reset it to default? It would work.
i have created a bridge added the Ethernet and wireless to the bridge and it’s worked fine . but is there any other solution
without creating a bridge?
can i solved the problem by routing? can i write the routes for communication between wireless and Ethernet.?