Interface Bonding 802.3ad (LACP)

[yihkhang87]

Hi all,

I trying to bond 2 ISP line. One is 20Mbps , another one is 10Mbps. I used balance rr was no issue, the only bad is just cannot reach to total 30Mbps. I try to use 802.3ad mode, but the bonding link will be disconnected. Port speed is same at both locations. Any idea?

Thank you in advance

[mrz]

You cannot use bonding unless it is enabled on ISP device.

[yihkhang87]

@mrz

You cannot use bonding unless it is enabled on ISP device.

Actually, this is the MPLS link with 2 different ISP Both site has the Mikrotik. I used bonding mode “balance rr” no issue

[yihkhang87]

@yihkhang87

@mrz

You cannot use bonding unless it is enabled on ISP device.

Actually, this is the MPLS link with 2 different ISP Both site has the Mikrotik. I used bonding mode “balance rr” no issue

DrawingQ.jpg

[yihkhang87]

Hi ,

Anyone can help me this issue?or any refence?