Interface rate bug

RouterOS General
1

Hi,

when I run command "/interface print" in terminal, I get:

NAME TYPE RX-RATE TX-RATE MTU

0 R ether5-vodojem ether 0 0 1500
1 R ether6-via2 ether 0

RX and TX rate are set to 0! however there is traffic on this interfaces. When i look thgrouh winbox -> interfaces, I can see TX and RX rate with no problems.

Am I doing something wrong or it's a bug?

thx

Testing on:
2.9.27
2.9.28
2.9.38

2

‘tx-rate’ and ‘rx-rate’ in the CLI are not equal to the rates shown in the Winbox.
If you want to get the same values in CLI, use ‘interface monitor-traffic ether1’ or any other interface name.