Setup my first IPsec tunnel to a remote site today. Connecting to a netgear router. Followed the directions found here: http://gregsowell.com/?p=787
The issue I’m having is that I cannot ping addresses on the remote site but they can ping addresses on my site.
When I run a tracert, I get a reply and see traffic returned (see below)
Is there any config on the mikrotik that would be causing this strange behavior? I suspected a route issue but have not been able to figure it out. tried several route changes with no success. Setting routes was not part of the setup instructions.
Any ideas?
C:\Users>ping 172.30.32.45
Pinging 172.30.32.45 with 32 bytes of data:
Request timed out.
Request timed out.
Request timed out.
Request timed out.
Ping statistics for 172.30.32.45:
Packets: Sent = 4, Received = 0, Lost = 4 (100% loss),
C:\Users>tracert 172.30.32.45
Tracing route to 172.30.32.45 over a maximum of 30 hops
1 <1 ms <1 ms <1 ms mikrotik.nts1.net [192.168.198.1]
2 36 ms 35 ms 35 ms 172.30.32.45
3 ^C
C:\Users>