IPV6 + BGP + OSPF problem

RouterOS Forwarding Protocols
1

Hello
I have a strange problem with IPV6+BGPv6+OSPFv6.

I have two routers. One of them is Juniper MX80, and the second is RB CCR. They have ospf v6 adjacency, and ibgp v6 session established. The MX80 works as bgp router reflector.

CCR gets full feed bgp ipv6 table from CCR, and routes from ospfv6(as IGP protocol) protocol to get next hops which are connected to the MX80.

In the ipv6 routing table, I can see that ccr know every direct connected networks to the mx80 and can ping them(I have eported static and direct from juniper). But All ipv6 feed from bgp is marked as unreachable. I use ospfv6 because I do not want to use ‘force next hop self’ at the MX80 (cisco and juniper doc says that route reflectors should not change next hop attrbitue because in some scenarios it can cause the loop).

At the attach you can see…that the network: 2001:1900:5:2:2::1e0/126(e0-e3) is reachable, but the ipv6 address 2001:1900:5:2:2::1e1 is unreachable.
The question is why?

Best regards.
Zrzut ekranu 2015-01-23 o 23.36.09.png

2

I would like to add, that if I set up a static route to address 2001:1900:5:2:2::1e1 via MX80 non link local addres, then the route changes its status to recoursive…

So why can’t it be via link local which is advertaised by ospfv6?

3

Everything is clear, the answear from support,

"Hello,

This is currently RouterOS v6 limitation.
Recursive IPv6 Link local nexthops will work in version 7."

Best regards.