Hi,
I want to connect a VoIP device to the existing IPv6 network. This device should receive a IPv6 address by using stateless auto config. Basically this works if I connect the VoIP device to the local LAN interfaces of the RB3011. The wireless network is configured as CAP interface runnning in access point mode on the RB3011. Now I want to use an mAP2n to bridge the network so that I can connect my VoIP device to the mAP2n.
The question now is which wireless mode do I have to use on the AP2n. I have tried to use “station-pseudobridge” but I doesn’t work. I did a similar setup with IPv4 and station-pseudobridge did its job.
Here is a small overview:
WAN IPv6 PPPoE—RB3011—CAPs AP—( wireless )—mAP2n—VoIP(LAN)
Thanks for the help!
Regards Toby