Issues with CAPsMAN Configuration on cAP ax (wifiqcom) via VLAN

RouterOS Wireless Networking
1

I am experiencing issues with CAPsMAN configuration on my network and would appreciate some guidance. Here’s the setup:

I have three cAP ax access points, all running RouterOS version 7.15 with the wifiqcom package.
CAPsMAN is configured on my main router, a CRS326, also with the wifiqcom package.
The access points connect to the CRS326 via VLAN 30, which is configured on ether2, through a Cisco switch.
The CAPsMAN configuration is applied correctly, and all three access points are configured without any errors.
The problem I’m facing is that my clients are not receiving IP addresses via DHCP. The DHCP server is correctly set up on VLAN 30.

My main question is: Can I use a VLAN instead of a Bridge in the Datapath configuration for CAPsMAN? The reason for this is that I have multiple VLANs configured on ether2, so bridging this port is not an option.

Any help would be greatly appreciated.

2

You don’t need wifi package on CRS, it doesn’t have wifi. CAPsMAN is part of base RouterOS package since 7.13.

You must use bridge on CAPs, and you may use VLAN on CAPsMAN.

Post your configs, both sides…

/export file=SomeName

Remove serial numbers, passwords (there shouldn’t be any), etc.
(make 3 new lines between code blocks)