Hi guys,
I have been struggling with this for a week now and figure someone might just be able to help in 0.00254 seconds 
I am trying to setup a queue on ip’s on a local lan. The range is 192.168.0.0/24 and I have a RB750 with ether3 and ether4 bridged. I have given the bridge an ip (192.168.0.165) as well as ether3 (192.168.0.166) and ether4 (192.168.0.167) both ip’s also.
I have given ether1 an ip (192.168.0.168). I need to graph traffic from specific ip’s on the same range. From 100 to 130 for example and I just can’t get the queue to show the traffic in the “traffic” tab or plot it in the graphs.
All traffic has to go through the bridge to get to the internet which is at 0.12 on the other side of the bridge (and that it does successfully).
I have tried default queue, small-queues and every option I can find.
I have been given the following instructions and can’t seem to get them working, can you find the problem?
Instructions:
create a queue
under the general tab put in the IP at the target address.
under the advanced tab change the queue type to default, you will see the traffic going in the traffic tab.
then go to tools → graphing
go to queue rules and add a rule for all queues 0.0.0.0/0
Thanks in advance,
Zenon