L2TP VPN Server Setup using failover WAN

RouterOS General
1

Good Day!

I would like to ask what additional configuration is needed to use the WAN failover as the IP of setting up an L2TP Server. If you asked why not used the mainline, I can’t cause it’s behind NAT and I need to contact my service provider and it will take longer.

So, What additional config do I need to route the connection and used my Failover ISP instead?

I hope someone can help me thank you so much in advanced.

2

Read this topic first. If you encounter problems, come back here with questions. There is no need to create IPsec configuration manually - the IPsec peer created dynamically when you set use-ipsec to yes or required under /interface l2tp-server server will respond from the address on which it has received the incoming connection.