LED COMMAND...

RouterOS Scripting
1

HI,
I can’t found LED command on scripting list… I use RB532 board. Any idea?

Regards
Xandor

2

There is ‘blink’,
and you may set ‘blink duration=10’.

3

HI,
But for enable led1, led2, led3, etc…

Regards
Xandor

4

You can use Ether1,Ether2, Ether3.
‘interface ethernet blink ether1’.

5

HI,
I need to enable led onboard to RB532, in your script exampèle I have found it:

[admin@MikroTik] > :
beep execute global list pick time toip typeof
delay find if local put toarray tonum while
do for led log resolve tobool tostr
environment foreach len nothing set toid totime
[admin@MikroTik] >

If you see led command is present, instead isn’t present into my RB532.

I have to add any new package on RB532 for obtain it?

Regards

6

HI again,
I need to use wireless interfaces and not ethernet.
In wireless blink command isn’t available.
I need a script for associate radio signal level to inside led on RB532.
Idea can be:

No signal:
/sys scheduler set 0 on-event=“/blink duration=100ms” interval=1s

-95 to -90
/sys scheduler set 0 on-event=“/blink duration=250ms” interval=1s

-90 to -85
/sys scheduler set 0 on-event=“/blink duration=400ms” interval=1s

-85 to -80
/sys scheduler set 0 on-event=“/blink duration=500ms” interval=1s

-80 to -75
/sys scheduler set 0 on-event=“/blink duration=750ms” interval=1s

-75 or less:
/sys scheduler set 0 on-event=“/blink duration=1s” interval=1s

But I need support for connect this script to radio signal level of wireless interface

Regards