LED setup for modem signal strength

Hardware MikroTik hardware general
1

Hi Guys

Can we setup LEDS for modem signal strength (signal strength onn 3G modem) i-e -60 to -70 LED1, -71 to -81 LED2 and so on

Thanks

2

you can set up LEDs in menu “/system leds” and specify type “modem-signal”, then configure threshold:
http://wiki.mikrotik.com/wiki/Manual:System/LEDS#Configuration_Properties

3
4

samir494, question was about 3G modems

5

thanks,

i send code for ref. ,
actual interface & type is depend on user to set as his require

6

Thanks Normis and Samir494 for your responses but it doesn’t work as expected

I have set LEDs as described below

LEDS Threshold
LED1 -60
LED2 -70
LED3 -80
LED4 -90
LED5 -100

At the moment, 3G signal strength on my device is -93 and LEDS from 1-4 are ON. If I use just one LED (e-g LED1) with Threshold -60, it will be ON even when signal strength is below -90.These LEDS needs to work other way around
Now I’m not able to put some range in threshold (e-g <=70 or -70 to 90 for LEDs) for modem signal strength.

Can you please provide some assistance on this please.

7

I have the same issue as m2mconnectivity.

Is it possible to invert the LED’s?

8

Currently RouterOS modem LED setting supports only one LED. We could check if we could add invert option for the LED.