License

Hi All

I have just installed a Level 4 License of RouterOS, but when I try to select AP Bridge Mode I get the following Error, I already had a license but because of this error was not sure if I have the correct license so I brought another license.

Can anyone help me out here.

The error is “Coudn’t Change Interface - License does not allow AP Mode”

Cheers

Piri

So when you type “/system license print” it does show level 4 correct? Have you rebooted the system since you put on the new license to make sure it took effect?

Yes

Sounds like a problem with the OS. Might want to try to upgrade or reload it. Otherwise email support.

in such cases, never buy anything before asking support. email a supout.rif to support[at]mikrotik.com

So I noticed that you did not reply with some support Normis ?

That would help since you are from MT

when you upgrade from 2.8.xx to 2.9.xx , you must buy license level 5=95$

or do, backup and restore on new 2.9.xx

I didn’t reply when and where? Isn’t this my reply above?

Normis - Reply with assitance (support) is what I ment

marko_bg - I already have a Level 4 license , should not have to buy another license to get this going, the isssue is some thing is wrong with my installation I suspect.

Piri

support only can help you in weekdays and during daytime. you would have to wait a few hours if you sent it at a different time.

piri,

ok,

I have this problem , when upgrade 2.8.xx to 2.9.xx , with license level 4

Cheers


:wink: nice interactive.....!!

marko_bg - ok cheers mate, thanks for your input. Looks like MT are comming to the party in the daytime.

Normis - I await your support in the day time, Cheers

What is a supout.rif ?

Piri

look in the manual … the supout.rif file is something you should know very well if you contact support: http://www.mikrotik.com/testdocs/ros/2.9/system/support.php

I will do as you say and send you the file

Regards

Piri

I have created the file and emailed it to support

Regards

Piri

Hi Normis

Any update on this please ?

Regards

Piri

support has not received anything from you. check spelling in email address you have send.

also, if you want to use AP mode with lvl 4 license you should install 2.9 not 2.8


so, install 2.9.39 and try again setting up mode=ap-bridge

I am resent the email, please advise when you have received it

Regards

Piri